Transom mount trolling motor brackets

RosebudRosebud Posts: 7 Greenhorn
I have two transom mount trolling motor brackets that I have used on my flats boat for a number of years. They are welded and anodized aluminum with a plexiglass base for the motor to mount to. These brackets will handle up to about 50 lb thrust motors due to the width of the bracket. They are for a transom angle of 12-15 degrees. They are in good condition, no cracks or other damage except minor corrosion from the bolt holes where they mount to the transom.
I went from two motors to one large one so needed a new mount, only reason for changing. The width of bracket is 4 3/4 inches by 5 inches high. The over all width is 5 1/4 inches.
Should a new bracket be manufactured (as I did) the cost would be at least $150.00 each.

Asking $75.00 for the pair.

Located in Carrabelle, FL.

[email protected]
850.545.5711










4
Sign In or Register to comment.